• Do not open the machine door when operating. In any case, the machine has a special
safety device which immediately stops the unit if the door is open, thus preventing water
spillage. Always switch the machine completely off and drain the water tank, before
accessing inside.
•
This machine must be disconnected from the main electrical supply after use at
the end of the day and for any service/maintenance operation following this
procedure:
Switch the machine off from the control panel.
Drain the tank by removing the overflow pipe.
Disconnect the electrical supply by the omni-polar switch (main switch located
on the wall).
Shut the water supply valve(s).
Disregarding the aforesaid prescriptions is a serious misuse and can cause
damages and injures to property and people, and will relieve the manufacturer
from whatever liability.
• Do not use old load pipe, but only new ones.
• The user must not carry out any repair and/or maintenance operations. In any case
contact qualified personnel.
• Do not use old load pipe, but only new ones.
• Do not put material or objects on the machine.
• Some important rules must be followed for using this appliance:
Never touch the appliance with wet hands or feet
Never use the appliance when barefoot
Do not install the appliance in places exposed to water sprays.
• Do not dip bare hands into water containing detergent. If this should occur, wash them
immediately with plenty of water.
• The washing and the rinsing water is not potable because of the presence of chemical
additives. In case of contact with skin or eyes wash them immediately with plenty of water
and check the safety instructions of the detergent manufacturer. If necessary, contact a
doctor.
• Only follow the instructions given in the manufacturer’s booklet for cleaning operations
(see chap.
5. MAINTENANCE
).
• The machine has an IP (see serial number label on the machine) protection rating against
accidental water splashes and is not protected against pressurized water jets. Pressure-
cleaning systems shall, therefore, not be used on this machine.
• This appliance is designed to work at room temperatures from 5 °C up to a max. 35 °C, in
a suitable room.
• Do not use water to extinguish fires on electrical parts.
• Do not cover the intake or dissipation grids.
• Water infeed to the machine 400 kPa maximum.
page 5
EN