Type of Problem
Possible Causes
Cure
Streaks and spots
on glasses and
dishes
Too much rinse aid
Decrease the amount of rinse aid by turning the
fine-adjustment screw on the dispenser (see
paragraph
Rinse aid dispenser
)
The water is too hard
Check the water quality. Water must not exceed 8
°f (5 °d) in hardness
For appliances with conditioners: too little salt in
the salt container or the resins have not been
properly regenerated
Fill the salt container (coarse salt: 1-2 mm grains)
and regenerate the resins more often. If lime
deposits are also observed on the body of the
machine, have a qualified technician check the
operation of the water softener
Salt present in dishwasher tub
Thoroughly clean and rinse the appliance, and
avoid spilling salt when filling the container
The appliance
suddenly stops
during the cycle
The appliance is connected to an overloaded
circuit
Connect the appliance separately (call the
Technical Assistance service)
A safety device has been activated
Check safety devices (call the Technical
Assistance service)
During wash cycle
the machine stops
and draws water
Water from the previous day has not been replaced Empty the tub and refill it
The tub water temperature is too high
Have the Technical Assistance service check the
thermostat and the pressure switch
Faulty pressure switch
The overflow tube is incorrectly positioned
Remove the overflow tube and correctly reposition
it
minutes-> Min,
day-> day,
month-> Mon,
year-> year).
Little pressure on feeding
Take out the boiler pipe and drain the pump
The washing
pump doesn't
work
The pump is blocked
Call the Technical Assistance service
Note: For any other problems, contact the Technical Assistance service.
The manufacturer reserves the right to alter the technical characteristics without prior notice.
page 24
EN