1.
2.
3.
4.
1.
2.
3.
Step 2. Install the Client Configuration File
To be able to run this client in stand-alone mode, or without requiring an explicit login through the web interface, you must install a configuration
file for the client on the remote system.
Log back into the
.
Go to the
page.
RESOURCES > My Network Connector
Hover over the icon for the client configuration file in the
section. A list of actions will appear.
My Network Connector
Select
.
Install Client Configuration file
When installing the configuration file, you may be presented with various
warnings depending on the security level that is configured on your system. Accept the warnings as
they appear in order to continue with the installation.
Step 3. Launch the Network Connector Client
Select
. A gray network icon will appear in the top right of your screen.
Finder > Applications > Network Connector
Click the network icon and choose
(where
may be a different network name, depending on how it was
Connect
Client
LAN1
LAN1
configured by
).
ssladmin
Enter your username and password when prompted, and click
.
OK
Using the Network Connector with Linux
No separate client software is needed to connect from Linux systems to the Network
Connector service, since most modern Linux distros already contain the required
support in the OpenVPN NetworkManager-openvpn packages. However, a
configuration file must be installed in order for the system to connect to the Barracuda
SSL VPN.
In this article:
Step 1. Install OpenVPN NetworkManager
Step 2. Download Client Configuration File
Step 3. Configure Network Manager
Step 4. Initiate the Connection
Related Articles
Using the Network Connector with
Using the Network Connector with
Step 1. Install OpenVPN NetworkManager
If it is not already installed on your system, i
nstall OpenVPN NetworkManager. Depending on your Linux distribution, you
may need to do this via one of the following methods:
Deb based Linux distributions (Ubuntu, Debian,...) – In a terminal enter:
sudo apt-get install network-manager-openvpn
RPM based Linux distributions (Redhat, SUSE,...) – In a terminal enter (as root):
yum install NetworkManager-openvpn
A client configuration file for the Network Connector is required only when using the Network Connector in stand-alone mode.
The Network Connector is available for use with Linux 2.4 or higher
integrated with the TUN/TAP driver.