Baroness LM315GG, Руководство по эксплуатации для владельца

Страница: 64 / 75

Wash off or wipe off with cloth etc. the
abrasive from the reel cutter (cutting
cylinder), then check it for sharpness.
Repeat steps 2 to 11 until the entire range
(three or four points from left edge to right
one) of the reel cutter (cutting cylinder) will
be uniformly sharpened.
Finally, apply the abrasive on the entire
range of the reel cutter (cutting cylinder) and
perform final lapping.
Stop the rotation of the reel cutter (cutting
cylinder), stop the engine, and then wash off
the abrasive using a washer etc.
While checking the blade for sharpness,
adjust blade engagement.
Adjusting CAM
Important
The figure below shows the situation when
you see from the left frame.
The right frame is mirror reversed.
When the gap at the left frame side between the
reel cutter (cutting cylinder) and the bed knife
(bottom blade) appears.
Loosen the locknut and turn the left cam
bush clockwise for the gap size.
When you raise the bed knife (bottom blade)
for 0.1mm (0.039 inch), turn the left cam
bush clockwise for 30 degrees.
Once the adjustment completed, tighten the
locknut securely.
When the gap at the right frame side between
the reel cutter (cutting cylinder) and the bed
knife (bottom blade) appears.
Loosen the locknut and turn the right cam
bush anticlockwise for the gap size.
11.
12.
13.
14.
15.
1.
2.
1.
Once the adjustment completed, tighten the
locknut securely.
A
B
C
D
E
4 3
A
1
2
4
ippmes_001
Adjusting CAM_001
1 Reel cutter (Cutting cylinder)
2 Bed knife (Bottom blade)
3 Lock nut
4 Cam bush
A Max 0.3 mm (0.012 inch)
B Bed knife (bottom blade) moving up
C Bed knife (bottom blade) moving down
D Center of cutter pin
E Center of cam bush
Attaching Reel Cutter (Cutting Cylinder)
Caution
Both the reel cutter (cutting cylinder) and the
bed knife (bottom blade) are edged tools.
Handle them carefully, since they could cut
your hands and feet.
Follow the instruction below to replace the reel
cutter bearing (right/left) and seal.
Use 30204JRP6 as bearing.
Fill up (Excelite EP No.2) to the bearings and
seal.
2.
1.
LM315GC
Maintenance
Page 5-10 Maintenance (Mower)