Baroness LM315GG, Руководство по эксплуатации для владельца

Страница: 39 / 75

Again, make sure that the cutting height is at
the required position by applying the cutting
height gauge to the front and rear rollers at
each edge of right and left of the mower unit.
Adjustment of Groomer
Caution
For adjustment, be sure to use the cutting
height gauge so that the right and left
sides can be parallel.
Otherwise it may cause damage on the
bearings.
Set the grooming height more than 0.0
mm from the ground.
Otherwise it may cause damage on the
groomer shaft, bearings and gears etc.
When using the grooming brush, set it to
the same height as the cutting height.
If it is set lower, it may wear easily.
Set the groomer screw of the cutting height
gauge to the desired height.
5
1
3
4
2
2qrq2r-002
Adjustment of Groomer_001
1 Front groomer
2 Groomer screw
3 Cutting height gauge
4 Grooming height
5 Front roller
8.
･
･
･
1.
Loosen the nuts fixing the right and left
groomer adjustment bolts.
1
2
3
2qrq2r-001
Adjustment of Groomer_002
1 Groomer adjustment bolt
2 Nut
3 Groomer adjuster
Adjust the groomer adjuster so that the
groomer screw can contact with the cutting
edge of the groomer.
Place the cutting height gauge set to the
desired height on the ends of the front and
rear rollers.
Adjust the groomer adjuster up and down
so that the right and left sides can be
parallel.
Adjust it at the other side in the same
manner.
Tighten the nuts securely after adjustment.
9 1
5
10
8
6
2 7
3
4
11
3kws2a-009
Adjustment of Groomer_003
2.
3.
[1]
[2]
[3]
[4]
Handling Instructions
LM315GC
Handling Instructions
Page 4-19 Adjustment Before Operating