Baroness LM315GG, Руководство по эксплуатации для владельца

Страница: 38 / 75

Adjustment of Cutting Height
Adjust the cutting height to fit your cutting work.
Important
This applies the set cutting height that differs
from the actual cutting height.
You can adjust the rear roller by six stages.
Attach the rear roller in a position within the
range of cutting height that suits your work
requirements.
Note:
The figure below shows the position of the
rear roller bracket with a new reel cutter
using 2mm bed knife.
1
2
3
A B C
D E F
3kws2a-008
Adjustment of Cutting Height_001
1 Mower frame
2 Rear roller bracket
3 Rear roller
A Use when the reel cutter is worn out
B 2.0 - 7.0 mm (0.079 - 0.276 in)
C 4.5 - 10.0 mm (0.177 - 0.394 in)
D 8.5 - 14.0 mm (0.335 - 0.551 in)
E 12.5 - 17.5 mm (0.492 - 0.689 in)
F 16.0 - 20.0 mm (0.630 - 0.787 in)
Set the slide caliper to the required cutting
height, adjust the neck position of the cutting
height screw of the cutting height gauge and
securely lock with a fly nut.
Loosen the nut which fixes the roller bracket
of the front roller.
1.
2.
3.
Apply the cutting height gauge to the front
and rear rollers at each edge of left and right
of the mower unit.
5
4
2
6 2
7
1
3
8
3kws2a-010
Adjustment of Cutting Height_002
1 Cutting height
2 Cutting height gauge
3 Cutting height screw
4 Nut
5 Front roller
6 Rear roller
7 Bed knife (bottom blade)
8 Roller adjuster
Adjust the front roller up and down by the
roller adjuster to determine the position of
the front roller, in order not to have a gap
with the neck position of the cutting height
screw of the cutting height gauge, at the
edge of the bed knife.
3
4
2
1
3kws2a-007
Adjustment of Cutting Height_003
1 Bed knife (bottom blade)
2 Cutting height screw
3 Cutting height gauge
4 Cutting height
Repeat the same process at the opposite
side for the adjustment of cutting height.
Tighten the nuts which fix the right and left
side of the roller bracket to fix them securely.
4.
5.
6.
7.
LM315GC
Handling Instructions
Page 4-18 Adjustment Before Operating