![background image](http://html1.mh-extra.com/html/barco/cine-8/cine-8_manual_3991150018.webp)
Installation guidelines
3-7
5976065 BARCOCINE 8 08022000
Note
After setting the scan switches, close the metal protection plate and secure it with the retaining screws.
Close the top cover and reconnect the power cord to the wall outlet.
Switching over from Floor to Ceiling or vice versa requires a complete readjustment of picture geometry and convergence.
Check Procedure
To check the current positions of the scan switches, proceed as follows:
Attention :
This procedure can only be done after power (mains) connection. So, first continue with the projector setup and the
connections and then return to this procedure.
-
Switch on the projector. The projector starts up on the last selected source.
-
Press the ADJUST
to start up the adjustment mode (menu 1).
-
Push the cursor key ê or é to select Service.
-
Press the ENTER. The
'SERVICE MODE MENU' will be displayed (menu 2).
-
Push the cursor key ê or é to select Identification.
-
Press the ENTER. The identification screen will be displayed (menu 3).
This screen gives the current information about the projector configuration in the line entitled
'Config'.
All projectors leave the factory set for a ceiling/front configuration.
ADJUSTMENT MODE
Select with
é
or
ê
then <ENTER>
<EXIT> to return.
Select a path from
below :
IRIS
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
source 1
menu 1
Select with
é
or
ê
then <ENTER>
<EXIT> to return.
SERVICE MODE
menu 2
Proj. address : 001
Soft. Version : 6.00
Config. : Ceiling
Front
Baudrate PC : 9600
Text : ON
Serial No. : 103589552
CINE 8
menu 2
I
DENTIFICATION
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
MORE ...