![background image](http://html1.mh-extra.com/html/barco/cine-8/cine-8_manual_3991150038.webp)
Installation adjustment mode
7-4
5976065 BARCOCINE 8 10022000
CRT Projection Angle Adjustment
What has to be done ?
The projection angle of the red and blue CRT's is dependent on the desired size of the projected image. If the centers of green, blue
and red do not coincide, the CRT projection angle must be adjusted.
NOTE
Never try to correct this misalignment with the shift correction or the static convergence controls. These controls may only be applied
to correct small errors which cannot be corrected by the CRT angle adjustment.
The Horizontal Shift and Vertical Shift for Red and Blue should be set near 50%.
Be sure that the rasters are centered on the CRT faceplate.
How to adjust ?
Press ENTER to start the CRT angle adjustment procedure.
Press ENTER to continue with the second part of the CRT projection angle adjustment.
Press ENTER to continue with the crosshairs alignment.
Press EXIT to return to the previous menu.
Press ADJUST to return to Operational mode.
CRT PROJECTION ANGLE
ADJUSTMENT
<ENTER> to read more
<EXIT> to return
CRT PROJECTION ANGLE IS
THE FIRST STEP OF STATIC
CONVERGENCE ADJUSTMENT.
IT IS CRITICAL THAT THE
RASTERS ARE CENTERED ON
THE CRT FACE PLATES
PRIOR TO PERFORMING
THIS STEP.
...
CRT
PROJECTION ANGLE
ADJUSTMENT
Align crosshairs
<ENTER> continue
<EXIT> to return
CRT PROJECTION ANGLE
ADJUSTMENT
<ENTER> to continue
<EXIT> to return
DURING THIS PROCEDURE,
RED ON GREEN AND THEN
BLUE ON GREEN CROSSHAIRS
WILL BE DISPLAYED
TO ALLOW THE RED AND
BLUE CRTS TO BE ALIGNED
WITH THE GREEN CRT.
LOOSEN BOLTS A AND B
TO PIVOT THE RED CRT,
AND BOLDS C AND D
TO PIVOT THE BLUE CRT.
Press ENTER to activate the raster on the Red CRT faceplate.
Shift the Red raster with the control stick until the raster is centered on the CRT faceplate.
Press ENTER to activate the raster on the Blue CRT faceplate.
Shift the Blue raster with the joy stick until the raster is centered on the CRT faceplate.
Press ENTER to continue with the CRT projection angle adjustment.
Press EXIT to return to Optical focusing.
Press ADJUST to return to Operational mode.
Correct raster position
Wrong raster position
menu 1
menu 2
menu 3