Barco Balder, Руководство по установке

Страница: 26 / 58

3. Physical Installation
Parameter Value
Thread size M12
Length 18mm max 18mm max
Where possible, the projector lens must be positioned exactly perpendicular to the center of the screen. Use
the projector offset (lens shift), rather than physical angling, to correct any off-center positioning.
C
AUTION
:
The position and physical securing of the projector must be suf fi cient to prevent it from accidental
or involuntary movement. Proper securing of the projector is the responsibility of the installer and user.
C
AUTION
:
Always use a Rigging Frame when the projector shall be mounted in other ways than on the feet,
on a fl at surface.
The threaded hole in the lower back end of the projector is NOT suitable for lifting or other heavy operations.
Only for adjustment purposes.
Installation and use of the Rigging Frame are described in document R5906768 Multifunctional Frame — In-
stallation Manual.
Mounting on a fl at surface
1. Position the projector at the desired location.
2. Power up the projector.
3. Go to Main Menu / Test Pattern s and select an internal hatch pattern to display on the screen.
4. Adjust the projector legs until the projected hatch pattern is a level and perfect rectangle.
Adjustable feet
Twisting the adjustable feet in either direction, left or right, allows you to fi ne-adjust the projector position for precise vertical me-
chanical alignment.
Raise
Lower
Image 3-2
Mounting to a ceiling
1. Install the projector in to an approved rigging frame.
2. Install the rigging frame to the desired location.
3. Power up the projector.
4. Go to Main Menu / Installation / Orientation and select the correct orientation for your setup.
5. Go to Main Menu / Test Pattern s and select an internal hatch pattern to display on the screen.
6. Adjust the position (height and angle) of the rigging frame until the projected hatch pattern is a level and perfect rectangle.
22 601–0442 BALDER 13/09/2017