Barco Balder, Руководство по установке

Страница: 30 / 58

3. Physical Installation
Apply a Scheimp fl ug correction
1. Loosen the three set screws (reference 1b, 2b, 3b). Use a size 6 hex key to do this.
1b
2b
3b
Image 3-6
2. Adjust the left side Scheimp fl ug adjustment screw (reference 1) until the test image in the top right side of the screen is in focus.
Use a size 4 hex key to do this.
Note: This process may cause the other areas of the image to slide out of focus. This is totally normal.
1
F
Image 3-7
3. Adjust the right side Scheimp fl ug adjustment screw (reference 2) until the test image in the top left side of the screen is in focus.
Use a size 4 hex key to do this.
Note: This process may cause the other areas of the image to slide out of focus. This is totally normal.
2
F
Image 3-8
4. Adjust the top Scheimp fl ug adjustment screw (reference 3) until the test image in the bottom half of the screen is in focus. Use
a size 4 hex key to do this.
Note: This process may cause the other areas of the image to slide out of focus. This is totally normal.
3
F
Image 3-9
5. Continue adjusting the screws one at a time until the test image is uniformly sharp across all areas of the display.
26 601–0442 BALDER 13/09/2017