BANTE A151, Инструкция по эксплуатации

Страница: 7 / 22

A151 Benchtop Conductivity Meter
6
Interval Readings
Off
When the option is enabled, the meter will automatically
send the measured data to the computer or printer.
Off
10 seconds
30 seconds
60 seconds
10 minutes
30 minutes
Password
Enable
Set the password protection for calibration and settings. Disable
Disable
Brightness Low, Mid, High Set the brightness level of the backlight. Mid
Clear Stored Data
Enable
Delete all stored readings in the memory. Disable
Disable
Factory Reset
Enable
Reset the meter to factory default settings. Disable
Disable
Setting the default option
1. In the measurement mode, press and hold the key for 3 seconds to enter the setup menu.
2. Press the

or

key to select the menu item.
3. Press the
Enter
key, the cursor changes to highlight.
4. Press the  or  key to select the desired option.
5. Press the
Enter
key to confirm, the meter returns to the measurement mode. Setting is completed.
Setting the default parameter
The meter provides two methods for parameter settings.
• Press the  or  key to modify the value, press the
Enter
key to confirm.
• If the cursor appears below the first digit, press the  or  key to set the value, press the
Enter
key to confirm and move to the next digit. Repeat
the steps above until the meter returns to the measurement mode. Setting is completed.

During the setting process, press the  or  key once, the setting value will increase or decrease gradually. Press and hold the  or  key, the
setting value will increase or decrease quickly.
Setup example - alarm limits
1. In the measurement mode, press and hold the key for 3 seconds to enter the setup menu.
2. Press the

or

key to select the “Alarm Limits”.
3. Press the
Enter
key, the cursor changes to highlight.
4. Press the  or  key to select the measurement unit, press the
Enter
key to confirm.
5. Press the  or  key to set the high alarm value, press the
Enter
key to confirm.
6. Press the

or

key to select the measurement unit, press the
Enter
key to confirm.
7. Press the

or

key to set the low alarm value, press the
Enter
key to return to the measurement mode.