BANLAW PRODUCT DATA SHEET
RESTRACK ADVANCED CONTROLLER
Doc ID: PRH-FMG-21 Version: 1.0
Page
8
of
20
Please ensure you have the latest version of this document.
3.
INSTALLATION AND COMISSIONING GUIDELINES
This Installation and Commissioning Guide is general, and is not meant to replace or override installation
guidelines that arise out of a
due diligence
assessment of a Banlaw product for a specific (intended)
application.
For any installations where these limits are likely to be exceeded, contact Banlaw for assessment and
advise.
The scope of this section applies to the Banlaw ResTrack
™
Advanced Controller assemblies. Whilst other
products are mentioned
–
e.g. Level Sensors and flow meters
–
end-users must refer to
separate
Banlaw
documentation covering each product
prior
to installation.
3.1
Pre-Installation Guidelines
The Pre-Install guide is available as an organisational tool to aid a complete installation of a Banlaw Advanced
Controller. The Advanced Controller is in essence a computer that is connected to your fuel delivery and
dispensing hardware. It provide security in who is able to use fuel and will deny an unauthorised user. It
catches and stores information automatically which can be reported on in the future, while showing flow
totals and tank levels locally to users.
The appropriate care should be taken to position the Advanced Controller out of direct sunlight. This can only
help reliability and prolong hardware life.
The Advanced Controller screens can be susceptible to scratching and damage by sharp objects. Like most all
equipment if the screen is used in its intended manor this will prolong hardware life.
Please choose all fasteners to fit the Advanced Controllers mounting lugs and to fit pre-drilled stands. Make
certain the correct tools are used to fasten all fasteners.
The cabinet is IP65 rated from factory. Please ensure all glanding methods are IP65 or greater.
General Installation Notes:
1.
Conduct a
Job Hazard Analysis
(JHA)
prior
to install to mitigate health, environmental
and equipment hazards.
2.
Do
NOT
install any parts or modify a previous Controller Installation without
assessment and advise from Banlaw.
3.
Do
NOT
install any parts that are damaged or are otherwise faulty.
4.
Do
NOT
install parts which are not compatible electrically with the Banlaw ResTrack
Advanced Controller.
5.
Do
NOT
install parts which are not approved by Banlaw.
6.
Do
NOT
install or modify any electrical parts if you are not certified to do so.
7.
Only engage threads of the same thread type. Ensure all threaded connections are
clean and in good condition. Avoid over-tightening.
