BANLAW PRODUCT DATA SHEET
RESTRACK ADVANCED CONTROLLER
Doc ID: PRH-FMG-21 Version: 1.0
Page
13
of
20
Please ensure you have the latest version of this document.
4.2.2
Light Vehicles
NOTE: This procedure is general and site procedures will have precedence.
Light Vehicle SecureFill Auto ID Refuelling
Step
Instruction
1
Insert Banlaw Splash Fill Nozzle into the Vehicle Fuel filler pipe.
2
If the ResTrack Advanced Controller
detects an Auto ID TAG it will display “Nozzle Enabled,
display fuel digits to check LCD is working, and Please Proceed” when this has finished the
Vehicle ID will be displayed on the LCD screen e.g. N1= 224
3
ResTrack Advanced Controller will open the fuel line actuator ready for the Pump to Start
4
START the Pump
5
Dispensed Fuel is displayed on the LCD screen for the respective Nozzle e.g. L1= 43.20
6
When refuelling has completed remove the splash fill nozzle and turn OFF pump and place
nozzle on holster or bowser. ResTrack will now detect zero fuel flow and after 30 seconds
will close the fuel line actuator. The volume dispensed is displayed until a new transaction
is initiated.
4.3
Manual Transaction - Delivery
The following process illustrates a typical operating sequence for an
FUEL DELIVERY
fuel transaction using
the Banlaw ResTrack
™
Advanced Controller.
Equipment that is damaged, leaking or otherwise unfit for
operation must not be used
. Maintenance should be carried out to replace or repair faulty parts prior to use
of a diesel refuelling system.
Manual deliveries can be started by
selecting the “DELIVERY” button
.
Figure 10: Delivery button
The Manual Delivery button will prompt for a Unit ID, and Pin Number that would be allocated by the site
fuel champion. The delivery operator is required to punch in the docket/manifest number and the expected
delivery volume, which is to be delivered.
With all this information inserted
press the “Done” button to start the delivery.
