Balluff BVS HS-QB-SDR-MA-02-02, Руководство по эксплуатации

Страница: 234 / 296

234
BVS HS-Q Series
Standard Hand Held Barcode Reader
5
References
5.3.1 Global Prefix/
Suffix
Up to 20 ASCII characters may be added as a prefix (in a position before the barcode data) and/
or as a suffix (in a position following the barcode data) as indicated in Figure 2:.
Figure 2: Prefix and Suffix Positions
Prefix Suffix AIM ID Label ID Label ID Bar Code Data
00 - 20 Characters (ASCII)
AND
OR
OR...
Example: Setting
a Prefix In this example, we’ll set a prefix for all symbologies.
1 Determine which ASCII character(s) are to be added to readed barcode data. In this example,
we’ll add a dollar sign (‘$’) as a prefix.
2 Go to page 57 and scan the ENTER/EXIT PROGRAMMING MODE barcode, then scan the
SET GLOBAL PREFIX barcode.
3 Reference the on page 294 on the inside back cover of this manual to find the hex value
assigned to the desired character. The corresponding hex number for the ‘$’ character is 24.
To enter this selection code, scan the ‘2’ and ‘4’ barcodes from
Appendix 18, Use the bar-
codes in this appendix to enter numbers as you would select digits/characters from a key-
pad.
.
If you make a mistake before the last character, scan the CANCEL barcode
to abort and not save the entry string. You can then start again at the begin-
ning.
4 If less than the expected string of 20 characters are selected, scan the ENTER/EXIT barcode
to terminate the string.
5 Scan the ENTER/EXIT barcode once again to exit Programming Mode.
6 The resulting message string would appear as follows:

Readed barcode data: 12345

Resulting message string output: $12345