Baldor MicroFlex e100, Руководство по установке

Страница: 38 / 172

www.baldormotion.com
3-24 Basic Installation MN1942
3.7 Regeneration resistor selection
The following calculations can be used to estimate the type of regeneration resistor that will be
required for the application.
3.7.1 Required information
To complete the calculation, some basic information is required. Remember to use the worst-case
scenario to ensure that the regeneration power is not underestimated. For example, use the
maximum possible motor speed, maximum inertia, minimum deceleration time and minimum
cycle time that the application might encounter.
Requirement Enter value here
a) Initial motor speed, before deceleration
begins, in radians per second.
Multiply RPM by 0.1047 to give radians
per second.
Initial motor speed, U = _________ rad/s
b) Final motor speed after deceleration is
complete, in radians per second.
Multiply RPM by 0.1047 to get radians
per second. This value will be zero if
the load is going to be stopped.
Final motor speed, V = _________ rad/s
c) The deceleration time from initial speed
to final speed, in seconds.
Decel time, D = _________ s
d) The total cycle time (i.e. how frequently
the process is repeated), in seconds.
Cycle time, C = _________ s
e) Total inertia.
This is the total inertia seen by the drive,
accounting for motor inertia, load inertia
and gearing. Use the Mint WorkBench
Autotune tool to tune the motor, with the
load attached, to determine the value.
This will be displayed in kg·m
2
in the
Autotune tool. If you already know the
motor inertia (from the motor spec.) and
the load inertia (by calculation) insert the
total here.
Multiply kg·cm
2
by 0.0001 to give kg·m
2 .
Multiply lb-ft
2
by 0.04214 to give kg·m
2 .
Multiply lb-in-s
2
by 0.113 to give kg·m
2 .
Total inertia, J = ________ kg·m
2