Baker Hughes Druck DPI 620 Genii, Инструкция по эксплуатации

Страница: 160 / 166

Copyright 2013 Baker Hughes Company.
148 | DPI 620G Instruction Manual–English
Chapter 12. Calibration Procedures
5. Check the calibration is correct:
a. Select the applicable pressure function via the Calibrator Task Menu.
b. Apply the following pressure values for absolute sensors:
%FS: 0, 20, 40, 60, 80, 100
%FS: 100, 80, 60, 40, 20, 0
c. Apply the following pressure values for gauge sensors:
%FS: 0, 20, 40, 60, 80, 100
%FS: 100, 80, 60, 40, 20, 0
d. Check the error is within limits.
e. Refer to the sensor datasheet and use the values in the total uncertainty column.
f.
The specified values include an allowance for temperature changes, reading stability for
one year, and the uncertainty of the standard used for calibration.
12.15 Procedures: TERPS USB
Refer to the user manual K0473, Druck TERPS. Refer to Section 12.14 for procedure.
When the calibration is complete, the instrument automatically sets a new calibration date in the
sensor.
12.16 Procedures: RTD - INTERFACE
Do the procedure as follows:
1. Connect the RTD
- Interface to the DPI 620 Genii.
2. Connect the RTD probe to the temperature standard.
3. Let the equipment get to a stable temperature (minimum: 1
hour since the last power on).
4. Use the calibration menu (see Section 12.1) to do a two-point temperature (resistance)
measure calibration (0 to 400 Ω range):
• Zero and +FS
Table 12 - 18: Calibration Pressures (Absolute Sensors)
Pressure Range Nominal Applied Pressure mbar (psi)
bar (psi) Zero +FS
350 mbar (5.0) < 1.0 (0.02) +FS
2 bar (30.0) < 5.0 (0.07) +FS
7 bar (100.0) < 20.0 (0.29) +FS
20 bar (300.0) < 50.0 (0.73) +FS
350 bar (5000)
Use atmospheric pressure as
zero.
+FS