Bailey Approach Autograph Series, Руководство пользователя

Страница: 31 / 193

29
TR
AVELLING
2. Make sure that the on-off button (3) is set to
off (button not pressed). Insert the electrical
connector (11) into the 12V socket in the vehicle
and start the engine.
3. Turn the function select dual (2) to the left
(Tyre icon). Press the on-off button (3) to start
the compressor. When the pressure gauge (4)
shows the required pressure for the vehicle,
switch off the compressor by the on-off button
(3) If, after 10 minutes from the compressor
being switched on, the pressure gauge (4) still
shows pressure of less than 3 bar / 43psi, switch
off the compressor and disconnect the sealant
tube (8) from the tyre valve. Tighten the valve
cap on the valve and move the vehicle about 10
metres to allow the sealant to be distributed
inside the tyre. Stop the vehicle in a safe place
and repeat the above procedure until the tyre
reaches the correct pressure. If, after 10 more
minutes of compressor use, the pressure gauge
(4) continues to give pressure reading of less
than 3 bar / 43 psi, The tyre is too damaged
to repair. Disconnect the kit and return it to its
compartment, then call for roadside assistance.
4. If the tyre has reached the required pressure,
then you may continue driving. Do not exceed
80 KM/H. Do not accelerate or brake suddenly.
After driving for about 8 km / 5 miles, park the
vehicle in safe place that you can easily access,
and engage the handbrake. Take out the kit,
make sure than the on-off button (3) is set to
off and inset the electrical connector (11) into
the 12V power socket in the vehicle. Remove
the cap from the repaired tyre valve, take out
the black inflation tube (9) and connect then
firmly tighten it to the valve. Check the pressure
gauge (4) for the correct tyre pressure reading.
5a. If the pressure gauge give a reading
of less than 3 bar / 43 psi, The tyre is too
damaged to repair. Disconnect the return it
to its compartment, then call for roadside
assistance. If the pressure reading is 3 bar /
43 psi or above, turn the function select dial
(2) to the right (pump icon), switch on the
compressor and inflate the tyre to the required
pressure. Disconnect the kit and return it to
its compartment. Drive carefully and take the