Bailey Approach Autograph Series, Руководство пользователя

Страница: 128 / 193

126
THE DOMETIC REFRIGER
A
TOR
The Dometic Refrigerator
Before you start using the refrigerator, please
read the operating instructions carefully.
Modes Of Operation
The refrigerator is equipped to operate on three
power modes:
> Mains voltage (230V AC)
> Direct-current voltage (12V DC)
> Gas (liquid gas propane/butane)
Select the desired power mode by the energy
selector switch 1 (see fig 1) (battery igniter type
models).
Explanation of operating controls
1 = Power On switch/ Energy selector switch
2 = Temperature controller
3 = Battery igniter (gas)
4 = Flame indicator (galvanometer)
Switch on the appliance by turning the energy
selection switch 1 clockwise to the desired
power source.
NOTE: In order to prevent discharge
of the on-board battery, 12V
operation should only be used while
the vehicle is running.
Electrical Operation
12v-voltage (on-board power supply)
The refrigerator should only be used in 12V DC
operation while the vehicle’s engine is running,
otherwise the on-board battery would be
discharged within a few hours!
Mains Power (230v)
This option should only be selected where the
supply voltage of the connection for power
supply corresponds to the value specified on
the data plate. Any difference in values may
result in damage the appliance.
Gas Operation (Liquid Gas)
The refrigerator must be operated using
liquefied gas (propane or butane NOT natural
gas or town gas). When using LPG please
consider that the burner needs cleaning at
shorter intervals due to the gas combustion
method (annually).
In Europe, gas operation is permitted while
travelling only on the condition that the gas
system of the vehicle is equipped with a hose
rupture protection. The national regulations
of the respective country must be observed.
(This applies to Autograph models only).
For physical reasons, gas ignition faults could
occur starting from an altitude above sea
level of approx. 1,000m/3,280 ft. (This is not a
malfunction!)
On the initial refrigerator start-up or after a
cylinder change, air may be trapped in the gas
line. To purge the air from the line, switch on the
refrigerator and any other gas appliances (e.g.
stove) for a short time. The gas ignites without
delay.
Each refrigerator with manual ignition is
equipped with an automatic flame safety valve
which interrupts the gas supply after approx
30 seconds when the flame has extinguished.