Baileigh TS-1040C, Руководство оператора

Страница: 62 / 84

59
59
To adjust the parallelism to the blade:
1. Disconnect and lockout power to the saw!
2. Loosen the two cap screws on the top front of
the fence.
3. Unlock the fence; align the left side of the fence
with the right edge of the miter slot, then lock
the fence.
4. Check to make sure the fence is parallel with
the miter slot.

If the fence is parallel with the miter slot, tighten
the cap screws.

If the fence is not parallel with the miter slot,
repeat Steps 3-4.
Clamping Pressure
A lock nut on the back of the fence adjusts the clamping pressure to hole the fence securely.
To adjust the fence clamping pressure:
1. Disconnect and lockout power to the saw!
2. Unlock the fence.
3. Using a 10mm socket, adjust the lock nut inside
the back of the fence to loosen or tighten the
fence clamping pressure.
4. Lock the fence handle and verify whether the
clamping pressure is satisfactory.
5. Re-adjust as needed until the fence will not
move as pressure is applied against it.
Fence Scale Calibration
The fence scale indicator windows can be calibrated with the fence scale by loosening the
mounting screw and sliding it in the desired direction. The indicator window on the right side is
used when the fence is positioned to the right side of the blade. The indicator window on the left
is used when the fence is positioned on the left side of the blade.
To calibrate the fence scale indicator windows:
1. Lock the fence at 13" and cut your scrap piece of wood.
2. Reposition and lock the fence at 12", as indicated by the scale.