Baileigh TS-1040C, Руководство оператора

Страница: 44 / 84

41
41
8. Turn the saw ON, and then slowly raise the blade to the maximum height that will be used
during normal operations.
9. Turn the saw OFF, and lower the blade completely.
10. Remove the board and clamps.
11. Install the blade guard. See "Installing Blade Guard & Spreader".
ALIGN-A-CUT
The Align-A-Cut marker is an insert on the table top which allows the operator to mark lines
which are in line with the kerf of the saw blade being used. The operator can then align the
cutting line on a workpiece with the blade kerf without the need to touch a blade tooth. When the
saw blade kerf changes the Align-A-Cut lines can be changed to match the new kerf.
Use the miter gauge to perform a cut on the right and
left sides of the workpiece, slide it back, then use a
pencil to mark the ends of the workpiece onto the
center of the marker.
If you install another blade, remove the pencil marks
with a clean shop rag and mark new kerf lines.
1. Disconnect and lockout power to the saw!
2. Remove the fence, or slide it out of the way.
3. Mark the cutting line on the workpiece.
4. Place the miter gauge in the right miter slot with the workpiece.
5. Align the blade with the cutting line on the workpiece, then perform the cut.
6. Turn the saw OFF.
7. Slide the miter gauge and workpiece back, making sure the workpiece does not move side-
to-side, and then mark the end of the workpiece (the right kerf line) onto the marker.
8. Place the miter gauge and workpiece on the left miter slot.
9. Repeat Steps 5-7, and then mark the end of the board (the left kerf line) onto the marker.