Baileigh TS-1040C, Руководство оператора

Страница: 25 / 84

22
22
Note: The bracket on the back of the
fence must be seated below the rear rail for the fence
to function correctly.
36. Move the left face of the fence against the blade.
37. While holding the fence stationary, adjust the front
rail until the right fence scale zero mark aligns with
the centerline on the right fence indicator window.
38. Tighten the front rail fasteners, and then verify that
the front rail is parallel with the cast iron table and
extension wings.
Note: Use a straightedge to level the right and left rail pieces.
39. Secure the sliding rail plate to the support shaft
with an M4-.7 x 12 flat head screw, slide the
plate into rear slot on the front rail, then secure
the opposite end of the shaft with (1) M6-1 x 12
knob and (1) 6mm flat washer, as shown.
Ensure that the shaft is parallel with the
extension wing.
40. Insert (2) M6-1 square nuts into the slot on the
back of the left front rail, align the nuts with the
switch bracket mounting holes, then secure the
switch with (2) M6-1 x 12 Phillips head screws
and (2) 6mm flat washers