Baileigh TS-1040C, Руководство оператора

Страница: 59 / 84

56
56
Miter Slot to Blade Parallelism
The table saw will provide best results if the miter slot and the rip fence are adjusted parallel to
the blade. If either of these is not exactly parallel, your cuts and your finished work will be lower
in quality, but more importantly, the risk of kickback will be increased.
To adjust the blade parallel to the miter slot:
1. Disconnect and lockout power to the saw!
2. Use an adjustable square to measure the distance from
the miter slot to a carbide tip on the blade. Make sure
that the face of the adjustable square is even along the
miter slot.
3. With the end of the adjustable square just touching the
tip, lock the square in place. Now, mark the carbide tip
with a marker where you made this measurement.
4. Rotate the marked blade tip to the other end of the table
insert.
5. Slide the adjustable square down to the other end of the table insert, and compare the
distance from the marked blade tip to the end of the adjustable square.

If the blade tip measurement is the same on both sides, the miter slot is parallel with the
table; the procedure is complete.

If the blade tip measurement is not the same on both sides, the table will need to be
adjusted. Proceed to Step 6.
6. To adjust the table, slightly loosen the hex bolts
in the trunnion mounting locations and slightly
tap the trunnions in the needed direction.
Repeat Steps 2-5 until the blade and miter slot
are parallel.
7. Tighten the trunnion mounting bolts.