Baileigh TS-1040C, Руководство оператора

Страница: 43 / 84

40
40
Finally, while it may be tempting to use the riving knife for through cutting operations, ALWAYS
install the full blade guard and spreader for through cutting. The blade guard and spreader
provide more protection from injury and risk reduction than the riving knife. Therefore, we
strongly recommend that you use the blade guard assembly instead of the riving knife for
through cuts.
CUTTING A ZERO CLEARANCE INSERT
A zero-clearance insert is provided with the table saw to reduce workpiece tear out and increase
operator safety. The insert can be customized to fit a specific blade height or blade angle for the
applicable cutting operation.
1. Disconnect and lockout power to the saw!
2. Verify the blade is properly installed (refer to the
instructions in Blade Installation).
3. Place the table insert in position into the table.
4. Adjust the table insert set screws with a 2.5mm
hex wrench to make sure the insert is flush with
the table (use a straightedge as a guide), then
turn the lock knob to secure the insert.
5. Center a board at least 2" thick over the rear
opening of the insert. This board should be the
same length as the table is deep, plus or minus
1”. Clamp the board securely to the table top at
both ends, as shown. This will provide extra
support for the insert and reduce tear out when
cutting.
6. Set the blade angle at 0°. This will position the
blade 90° to the table top.
Note: To retain the zero-clearance ability of the insert included with this saw, we
recommend only raising the blade into the insert at 90°. If a zero clearance insert is needed for a
different application, we recommend a separate insert cut specifically for that application.

If you plan to use a dado blade to cut rabbets or dados, install the included dado blade
insert.
7. Connect the saw to power. Keep hands off table top, do not stand directly behind the blade
path, and wear eye protection.