Baby Lock Valiant BMV10, Инструкция и справочник

Страница: 268 / 316

266
■
For the standard type
Using a Phillips screwdriver, loosen the three screws
(one each at the top and on the left and right sides)
on the outside of the mounting jig two or three turns.
1
Screws
2
Phillips screwdriver
Pull the mounting jig toward you, and then use the
Phillips screwdriver to tighten the three screws (one
each at the top, left and right sides).
→
This completes the preparation of the mounting jig.
Attaching the cap frame
Put the cap into the cap frame attached to the
mounting jig, and then remove the cap frame from
the mounting jig with the cap clamped. Next,
attach the cap frame to the cap frame driver on the
machine.
■
Attaching the cap frame to the
mounting jig and putting a cap into
the frame
a
Attach the cap frame to the mounting jig.
Slide the cap frame onto the mounting jig, making sure
that the notch at the base of the brim holder on the cap
frame is aligned with the guide plate on the top of the
mounting jig.
1
Guide plate on mounting jig
2
Brim holder
3
Notch
Note
• Do not remove the three screws (one each
at the top, left and right), otherwise they
may be lost. Only turn the screws to slightly
loosen them.