Baby Lock Valiant BMV10, Инструкция и справочник

Страница: 264 / 316

262
Preparing to use the cap frame
■
Installing the cap frame driver
Remove the embroidery frame holder from the
carriage on the machine, and then install the cap
frame driver. Before removing the embroidery frame
holder, remove the embroidery frame. (Refer to
“Removing the embroidery frame” on page 68.)
a
Loosen and then remove the two thumb
screws and the embroidery frame holder.
1
Thumb screws
• The removed thumb screws remain attached to the
embroidery frame holder.
1
Put the two thumb screws back in the embroidery
frame holder.
b
Remove the two upper thumb screws of the
cap frame driver and set aside. Loosen the
two lower thumb screws (4 turns).
1
Upper thumb screws
2
Lower thumb screws
c
Pass the machine bed through the ring of
the cap frame driver.
1
Machine bed
Attach the cap frame driver to the carriage as
described below in steps
d
through
g
.
d
Insert the two thumb screws at the bottom
of the cap frame driver into the v-cuts in the
carriage, and then place the mounting plate
of the cap frame driver on top of the frame-
mounting plate of the carriage.
1
Notch in the carriage
2
Thumb screw of the cap frame driver
3
Mounting plate of the cap frame driver
4
Frame-mounting plate of the carriage
CAUTION
• Before changing any embroidery frame holder,
make sure your machine is turned off.
Note
• Be careful that the cap frame driver does
not hit any nearby parts, such as the
presser foot.