Baby Lock Embroidery Professional PLUS BMP9, Инструкция и справочник, Страница: 261 / 276

Troubleshooting 259
7
—————————————————————————————————————————————————————————————————————————————————————
Error messages
If the start/stop button is pressed while the machine is not correctly set up or if an incorrect operation is
performed, the machine stops and informs you of the error with a buzzer and an error message. If an error
message appears, correct the problem according to the instructions in the message.
To close the message, touch or perform the correct operation, then touch . If the message
appears again, consult your nearest Baby Lock retailer.
Some malfunction occurred. There are too many characters in
the curved text arrangement for
the selected embroidery frame.
Change the text arrangement or the
embroidery frame.
The installed embroidery frame is
too small.
Check which embroidery frames
can be used, and then install a
larger embroidery frame. (Refer to
page 47.)
The upper thread broke, the
thread came out of the thread
tension disc or a thread guide, or
the machine is not threaded
correctly.
Check that the thread passes under
the upper and middle thread
guides, and correctly thread the
upper thread. (Refer to page 55.) If
the thread is not broken, clean the
thread guides and the tension unit.
(Refer to page 246.)
The bobbin thread broke or ran
out.
Check that there is thread on the
bobbin and that approximately 50
mm (2 inches) of thread has been
pulled out, and then re-install the
bobbin. (Refer to page 36.)
The patterns you are editing take
up too much memory, or you are
editing too many patterns for the
memory.