Baby Lock Embroidery Professional PLUS BMP9, Инструкция и справочник

Страница: 107 / 276

If the Thread Breaks or the Bobbin Thread Runs Out While Embroidering 105
3
—————————————————————————————————————————————————————————————————————————————————————
If the Thread Breaks or the Bobbin Thread Runs Out
While Embroidering
If the thread breaks or the bobbin thread runs out while embroidering, the machine will automatically stop.
Since some stitches may be sewn with only one thread, go back through the stitching to a point where
stitches have already been sewn before continuing embroidering.
Note
●
If the thread sensor is turned off, the
machine does not stop until embroidering
is finished. Normally, the thread sensor
should be turned on. Refer to page 202.
●
Be careful when going back or forward
through the stitching since the embroidery
frame moves at the same time.
If the upper thread breaks
1
Re-thread the upper thread. (Refer to
page 55.)
2
Touch .
X
The stitch navigating screen appears.
3
Touch and to go back
through the stitching to a point where
stitches have already been sewn.
1 Each touch of this key moves one stitch back
through the stitching.
2 Each touch of this key moves ten stitches back
through the stitching.
The embroidery frame moves. Go back to
the point where stitches have already been
sewn.
If the needle bar is moved back too far
through the stitching, touch or
to go forward through the stitching.
1 Each touch of this key moves one stitch forward
through the stitching.
2 Each touch of this key moves ten stitches
forward through the stitching.
1
2
1
2