B-ALU Extern 180, Инструкция по установке и эксплуатации

Страница: 56 / 200

ENGLISH
15
6.
Environment, disassembly, storage and transport
6.1. Environment-friendly disassembly
Have the product disposed of only by an authorized disposal company!
It should be disassembled only by specialists.
6.2. Storage and transport
If the product needs to be stored or transported, care must be taken to provide good quality packaging for this purpose. It must be stored in
a dry environment.
7.
Programming instructions
7.1. Quick commissioning
The gate system is supplied with the most important default factory settings and can be customized within a few minutes: Prior to
programming, ensure that the mechanical stops for the opening and closing operations are present and have been adjusted. These have
been pushed as transport locks for the assembly.
ATTENTION: The shutdown mechanism for the force is out of operation during the learning procedure. Hence, ensure that there are no
persons or objects located in the hazard zone during the learning procedure. Make sure that no start or stop commands are issued and
that the photocell are not interrupted during operation.
Appears:
Default display with mains voltage present
Steady and continuous illumination: everything OK
Flashing: Fault
Keep the P2 „PROGR/OK“ button pressed for at least 4
seconds
Press the P2 „PROG/OK“ button 2 times. The gate opens
up to the internal Stopp, checks this and then saves it.
The gate closes automatically up to the internal stop,
checks this one again and then saves it.
INLINE 100
INLINE 120