SW3 Switch Functions
The switches on SW3 have the following functions. Unless otherwise noted, these settings apply only when
programming the 6416Y2 card manually from its on‑board DIP switches.
DIP Switch Block SW3 Functions
DIP Switch
Parameter
Function
1
Channel/Slot Control 1‑16
Activates m‑control for 6416m channels 1‑16 from the current
Yamaha device
2
Channel/Slot Control 17‑32 Activates m‑control for 6416m channels 17‑32 from the current
Yamaha device
3
Channel/Slot Control
33‑48
Activates m‑control for 6416m channels 33‑48 from the current
Yamaha device
4
Channel/Slot Control
49‑64
Activates m‑control for 6416m channels 49‑64 from the current
Yamaha device
5
RS‑422 Control Source
Select
(Backplane or DB9
connector)
Selects the source of the Yamaha RS‑422 remote control
information—directly from the console’s backplane connector,
or from the DB9 Remote connector (depends on the console)
6
Pad Mode
Controls how the 24dB pad built into the remote Pro64
preamps operate. Two choices are available: Auto Pad and
Manual Pad.
7
Preamp Control Group
assignment
Sets a Control Group (1‑4) for the console and 6416Y2 card;
allows only mic preamps in the same Control Group to be
changed
8
Note that any combination of switches 1‑4 on block SW3 can be used to send control to a specific range of active
Pro64 6416m mic preamp channels. This set of DIP switches will typically be set to less than or equal to the
total number of channels that the console can support—16 channels on the LS9‑16, 32 channels on the LS9‑32,
48 channels on the M7CL, and 64 channels on the PM5D.
29
dIP s
wItch
f
unctIons
