Unified Communications Module Installation and Maintenance
Page 8
15-601011 Issue 03l (28 August 2012)
IP Office
1.1 Unified Communications Module
This module is supported for IP Office Release 8.0 Q1 2012 Service Pack and higher. The module is an embedded server
that allows Linux based IP Office applications to be run within the IP Office control unit rather than requiring a separate
PC.
·
Supports
Voicemail Pro and or one-X Portal for IP Office applications. The module
is only supported by systems running IP Office Essential Edition, IP Office
Preferred Edition or IP Office Advanced Edition modes.
·
IP Office Users: Up to 200 users when running Voicemail Pro
and one-X Portal for IP Office. More than 200 users when
running just Voicemail Pro.
·
Simultaneous one-X Portal for IP Office Users: 50.
·
Maximum voicemail ports: Up to 20 ports when running
Voicemail Pro and one-X Portal for IP Office. Up to 40 ports
when running just Voicemail Pro.
·
Small Community Network: Maximum 6 systems.
·
Licenses
The presence of this module acts as an automatic Preferred Edition
license for the IP Office system, enabling 4 ports of voicemail. Additional
voicemail ports can be licensed up to a maximum of 20. A separate
Essential Edition license is still required as a pre-requisite.
·
IP500 Control Unit:
·
IP500 V2 Control Unit:
IP Office Release 8.0 Q1 2012 Service Pack
or higher.
·
Maximum per Control Unit: 1 per control unit.
·
IP500 Trunk Card Support:
·
!
WARNING: Do Not Remove the Port Cover Except for Maintenance
The card is supplied with a removable plastic cover that locates over the external ports (LAN, USB and HDMI) on
the faceplate of the card. This cover should always be in place during normal operation of the card. The cover
should only be temporarily removed during maintenance actions that require access to the ports and should be
replaced when the maintenance is completed.
·
!
WARNING: Card Remains Hot After System Shutdown
When removing an Unified Communications Module from a system, care should be taken not to touch the heat sink
on the module. The heat sink remains hot for a long period after system shutdown.
Ports
The card is supplied with a removable plastic cover that
locates over the external ports (LAN, USB and HDMI) on the
faceplate of the card. This cover should always be in place
during normal operation of the card. The cover should only
be temporarily removed during maintenance actions that
require access to the ports and should be replaced when the
maintenance is completed. Whilst removed, the following
ports are accessible:
·
LAN
This port is not used.
·
USB
These USB2 ports can be used for the temporary
connection of devices during
module maintenance
.
USB2 memory devices should be USB 2.0 compatible.
·
HDMI
This port can be used for temporary connection of a
video
monitor
during module maintenance.
76
79