Unified Communications Module Installation and Maintenance
Page 14
15-601011 Issue 03l (28 August 2012)
IP Office
2. Module Installation
Pre-Requisites
·
This manual assumes that the installer is already experienced with the installation of an IP500 V2 system, including
the installation of IP500 base cards. It also assumes that the installer is familiar with the configuration of a IP Office
system using IP Office Manager and System Status Application.
·
This manual assumes that the IP Office system has already been installed and licensed for IP Office Essential
Edition mode running IP Office Release 8.0 Q1 2012 Service Pack or higher.
·
The Unified Communications Module defaults to using the IP Office system as its source for time and date
information. Therefore the IP Office system must be configured to either use a specific external time server to
obtain its time or to have its time set manually.
Additional Documentation
Depending on the application to be supported by the Unified Communications Module, Voicemail Pro and or one-X Portal
for IP Office, the following manuals are also required plus any information requirements specified in those manuals.
·
one-X Portal for IP Office Administration Manual
This manual covers the installation and administration menus used for the one-X Portal for IP Office application.
This manual is essential if the one-X Portal for IP Office needs to be configured to support multiple IP Office servers
in a Small Community Network.
·
Voicemail Pro Linux Installation Manual
This manual covers scenarios where multiple servers are installed within a Small Community Network.
·
Voicemail Pro Administration Manual
By default the voicemail server will provide mailbox services to all users and hunt groups without any configuration
being needed. This manual covers the administration of the voicemail server using the Voicemail Pro client in order
to enable additional features.
Information Required
·
IP Office Service User Names and Passwords
Service user names and passwords for IP Office Manager and System Status Application access to the IP Office
system.
·
IP Address Details
The IP address of the IP Office system's LAN1 interface is used for the initial configuration of the module. During
that configuration separate IP address settings for the module are set.
·
Licenses
Check that you have the necessary licenses for the expected operation. The licenses must match the Dongle Serial
Number shown in the IP Office system's configuration.
Tools Required
·
Windows PC
This PC or an existing PC is needed to run IP Office Manager and System Status Application. The PC needs to have
a LAN connection to the IP Office control unit.
·
5mm Flat-blade Screwdriver
This is required to remove a slot cover from the front of the IP Office control unit and to secure the newly installed
Unified Communications Module.
·
Anti-Static Wrist Strap and Ground Point
These should be used when inserting and removing cards from the IP Office control unit.
Transferring Settings from Other Servers
If the module is replacing an existing Voicemail Pro and or one-X Portal for IP Office server, the settings from those
servers can be transferred to the module. The methods for this are outlined in the sections
Transferring Voicemail Server
Settings
and Transferring one-X Portal for IP Office Settings.
80