Avaya MultiVantage, Руководство по установке

Страница: 142 / 246

DS1/T1 CPE loopback jack
555-233-116
142
Issue 4 October 2002
Restoring DS1 administration
NOTE:
If you have a G700 Media Gateway, substitute XXXVS for UUCSS in the
following command, where XXX is the administered number of the G700 (for
example, 002), and VS is the slot number on the G700 of the Media Module
(for example, V3). The V is not a variable and needs to be included in the
command exactly where shown. A sample address for a DS1 circuit pack on
a G700 Media Gateway might look like this: 002V3.
1. At the management terminal, open the DS1 administration form. Enter
change ds1 UUCSS, where UU is the cabinet number, C is the carrier
letter, and SS is the slot number of the DS1 board.
2. Change to page 2 of the DS1 administration form.
3. Change the value of the TX LBO field to the original value that you wrote
down when you were ‘‘Administering the DS1 for the test’’ on page 138 .
4. Press
ENTER
to make the changes,
CANCEL
to quit without changes.
The service provider
successfully loop tested the
span, up to the smart jack. The wiring between the loopback jack and the smart
jack is suspect. Test, and make repairs, as needed.
You cannot locate and repair
the problem in the time
available and must terminate
the test. The test will not terminate normally in the absence of a
good framing signal. You have to reset the circuit pack.
Enter reset board UUCSS, where UU is the cabinet
number, C is the carrier letter, and SS is the slot
number of the DS1 board.
NOTE:
If you have a G700 Media Gateway, substitute
XXXVS for UUCSS in the above command,
where XXX is the administered number of the
G700 (for example, 002), and VS is the slot
number on the G700 of the Media Module (for
example, V3). The V is not a variable and needs
to be included in the command exactly where
shown. A sample address for a DS1 circuit pack
on a G700 Media Gateway might look like this:
002V3.
The test terminated normally. Proceed with ‘‘Restoring DS1 administration’’ .
Condition Solution