Avaya CallPilot 600r, Техническое обслуживание и диагностика, Страница: 82 / 106

Note:
Because some of the connections are difficult to reach after you install the fan
assembly, Avaya recommends that you connect the following cables first:
a. Left fan in the fan assembly to the Sys Fan 1 connector. Use the short
cable.
b. Center fan in the fan assembly to the Sys Fan 2 connector. Use the short
cable.
c. Right fan in the fan assembly to the Sys Fan 6 connector. (Left side of
board). Route the cable next to DIMM socket 1A (DIMM socket nearest
the processor socket), then across the center of the board, in front of the
processor socket.
d. Center fan in the fan assembly to the Sys Fan 3 connector. (Rear of
board). Route the cable next to DIMM socket 1A (DIMM socket nearest
the processor socket), then to the right side of the processor socket.
e. Left fan in the fan assembly to the Sys Fan 4 connector. (Left side of
board). Route the cable next to DIMM socket 1A (DIMM socket nearest
the processor socket), then to the right side of the processor socket.
12. Lower the right side of the fan assembly into place so that it catches under the hook.
Use caution to ensure no cables are pinched beneath the fan assembly.
13. Set the left side of the fan assembly into place.
14. Tighten the captive screw.
15. Connect the fan cables to the correct fan connectors on the front panel I/O board.
The fan connectors are labeled on the front panel I/O board. Look for FAN SYS
labels.
16. Replace the processor air duct. For instructions, see Removing and replacing the
processor air duct on page 75.
17. Replace the server cover. For instructions, see Removing and replacing the server
cover on page 74.
18. Take off the ESD strap.
19. Plug in the peripheral devices and Ethernet cables, connect the AC power cords,
and restart the server.
Replacing the MPB96 card
There is one MPB96 card in your server.
Replacing basic chassis components
82 Avaya CallPilot® 600r Server Maintenance and Diagnostics December 2010