Avaya CallPilot 600r, Техническое обслуживание и диагностика, Страница: 79 / 106

To replace a SCSI hard drive
1. Power down the server, unplug all peripheral devices and Ethernet cables, and
disconnect the AC power.
2. Remove the front bezel. For more instructions, see Removing and replacing the
front bezel on page 73.
3. Attach the ESD strap to your wrist and attach the other end to a known grounded
connection.
4. Press in on the green latch on the front of the hard drive carrier as shown in the
following diagram.
Figure 18: SCSI hard drive carrier
5. Pull out on the black lever to slide the carrier from the chassis.
6. Remove the four screws that attach the plastic retention device or the previously
installed hard drive to the drive carrier. Two screws are at each side of the retention
device or the hard drive. Store the plastic retention device for future use.
7. Remove the hard drive from the wrapper and place it on an antistatic surface.
8. Set any jumpers or switches on the drive according to the drive manufacturer's
instructions.
9. With the drive circuit-side down, position the connector end of the drive so that the
end is facing the rear of the drive carrier. For more details, see Figure 19: Hard disk
drive location in carrier on page 80.
10. Align the holes in the drive with the holes in the drive carrier and attach the drive to
the carrier with the screws that were attached to the plastic retention device.
Replacing a hard drive
Avaya CallPilot® 600r Server Maintenance and Diagnostics December 2010 79