Avaya CallPilot 600r, Техническое обслуживание и диагностика, Страница: 38 / 106

ARP command parameters
Table 12: ARP command parameters
Parameter Description
-a Displays current ARP entries by interrogating the current
protocol data. If inet_addr is specified, the IP and physical
addresses for only the specified computer appear. If more than
one network interface uses ARP, entries for each ARP table
appear.
-g Same as -a.
inet_addr Specifies an Internet address.
if_addr Specifies the Internet address of the interface where you can
modify the address translation table. If not present, the first
applicable interface is used.
eth_addr Specifies a physical address.
-N if_addr Displays the ARP entries for the network interface specified by
if_addr.
-d Deletes the host specified by inet_addr.
-s Adds the host and associates the Internet address inet_addr
with the physical address eth_addr. The physical address is
given as six hexadecimal bytes separated by hyphens. The
entry is permanent.
To run the ARP command from Windows
1. Click Start → Programs → Accessories → Command Prompt.
Result: The Command Prompt window appears.
2. At the Command prompt, type arp with the required parameters (for example, arp
-g 200.286.0.32).
3. Press Enter.
Result: The system runs the ARP command.
4. Type Exit to exit the Command Prompt window and return to Windows.
Using Windows online diagnostic tools
38 Avaya CallPilot® 600r Server Maintenance and Diagnostics December 2010