22
PROBLEM INDICATION
REMEDY
Buzzer is activated
for no apparent
reason
Door at delayed zone
(entrance) is open or
there has been detec-
tion of movement at
an exit/entry zone.
Day or Tamper zone
was activated
Keys ‘5’ or ‘7’ have been pressed, activating
the door Chime or the Fault Find function.
Arm and disarm the system.
Hold-down ‘9’ key to reset Day Zone or
Tamper alarm
Entry at protected
zone activates mini-
sounder at keypad
A warning signal is
heard before the
siren is triggered
Disarm system immediately upon entry at
zone. If delay time is too short, call your
installer to reprogram delay time
‘L’ is displayed
Battery is low,
faulty, or dead
Call your installer immediately
‘C’ is displayed
(blinking)
Telephone line
disconnected or dead
or the systems failed
to contact central
station
Call your installer immediately. Check your
telephone line
Siren was triggered,
but programmed
phone numbers were
not dialed
1. Faulty dialer
2. Faulty phone line
or phone off the
hook
3. Mistaken report of
alarm
1. Hold down ‘6’ key (dialer test);
automatically dialed numbers will be
displayed (test takes several minutes).
2. If the telephone line to the alarm control
has been disconnected, reconnect it.
3. Malfunction of the alarm system - call
your installer
‘H’ is displayed.
‘h’ is blinking.
A panic alarm was
activated. Take
emergency
measures. Blinking
‘h’; set the time
Arm and disarm system to abort alarm and
H display.
Set system time by holding-down ‘0’ key
then ‘1’ key
Yellow indicator
lights upon arming
of system, without
bypassing (pressing
0 and any key)
‘Automatic Bypass’
has been
programmed. Can
also occur if ‘0’ key
is pressed twice
before arming,
which activates zone
bypass
Before arming, make sure all entry/exit
doors protected by system are closed and all
detectors are off. Arm the system, and call
your installer