20
0
Shunt
and
#
#
LOCAL
BUZZER ON and OFF
Holding down keys "0" and "#" simultaneously turn on and off the buzzer in each
LCD keypad. This function works in disarmed mode.
Testing Your System
It is recommended to test your system weekly. Perform system tests in the off-
peak hours, such as early morning or late evening. Call to inform your
monitoring station that you are testing your system.
Siren and Battery Test
Hold-down ‘1’ key, this command will generate a siren sound for few seconds.
Turn off your main AC, verify that LEDs are blinking to indicate power failure; test
siren again to make sure your battery can drive the siren during power failure.
Arm and Disarm the system (main AC is still off) few times, if ‘L’ is displayed, your
battery is faulty, call your installer.
Detection Devices Test
Test
7
Key 7
#
FAULT FIND
•
Fault Find enables testing of all detection devices.
•
Fault Find mode can be entered only during the 15 seconds following system
Disarming.
•
Fire, 24H, or Panic alarm will stop Fault Find mode.
•
Hold down ‘7’ key, confirmed by ‘F’ on Keypad display.
•
Activate each sensor. Detection of zone opening is confirmed by a one-second beep.
Three beeps indicate zone closing.
•
Arm the system to quit Fault Find mode.
Testing your Central Station (CS)
Inform your CS that you perform testing, ask them to report you if an alarm is
received. Arm the system, move in front of a detector or open a protected door, verify
that the siren is activated; to quit testing, disarm the system.
Call your installer if any test fails to operate