Automatic Technology MegaCode, Руководство по установке

Страница: 11 / 23

Owner Installation Instructions MegaCode® Receiver 11
Transmitter Management
MENU 1
Code Transmitter
PR E S S
10 fi g
Press Tx’er
Button! LIST—»
PRESS
11 fi g
12 fi g
13 fi g
Press Tx'er
Again! VIEW—»
PRESS
The MegaCode® provides a transmitter listing facility
which enables the User to fi nd a transmitter location
within memory. Once located a stored transmitter can
be replaced, deleted, edited, copied or, if the location
is empty, a new transmitter can be coded.
Method 1 - Go to the start of the list
Accessing the list menu
1. Press NEXT to navigate to Menu 1.
2. Press SET to enter the transmitter edit procedure
(Fig. 10) .
3. Press NEXT to enter the transmitter list and edit
mode (Fig. 11) . This is used if the transmitter is not
available.
Method 2 - Use transmitter to go direct to list
Accessing the list menu
1. Press NEXT to navigate to Menu 1.
2. Press SET to enter the transmitter edit procedure
(Fig. 10) .
3. Press transmitter once (Fig. 12) .
4. Press NEXT to view transmitter parameters (Fig. 13) .
This is used for quick navigation if the transmitter is
available. The transmitter details will be shown
(Fig.
14) .
NOTE: “VIEW>” will not be shown if the transmitter is
not stored.
Once the list is displayed it can be sorted by stored
number, ID Label or Serial Number. Use NEXT or PREV
button to select sorting method.
NOTE: When sorting by ID label or S/N, only stored
transmitter locations are displayed.
Navigating the list
1. Press UP or DOWN buttons to navigate through the
list (Fig. 15) .
2. Press SET to display menu of available functions.
NOTE: Holding a button down will step through the
list faster.
14
fi g
51 ∆ ID T SMITH
M_3 T_4 R_1 S_2
Press Tx'er
Button! LIST—›
PRESS
31 ∆ ID T SMITH
P_1 --- R_1 T_2
PRESS
15 fi g