12
GDO-6v4 EasyRoller
®
Owner Installation Instructions
Installation
Step 1 - Preparation
Check the door’s operation:
The door must travel smoothly and be
easy to operate by hand.
Operating force on the bottom rail should
be approximately 70N (7kgs) force.
Adjust any tight or twisted guides/tracks
Clean the guides if there is any oil or wax
present using a suitable white spirit. The
only lubricant suitable for use on door
guides is silicon spray. DO NOT use WD-
40, RP-7, petroleum grease, or similar.
Install the locking bar covers if there are locking bar
holes in the guides.
(Fig.03)
IMPORTANT NOTE -
Do not lock your door
with the locking bars after installing the opener.
Remove or disable the lock using wire or cable
ties. Security is not affected as the opener has an
inbuilt locking facility.
Affi x the warning labels supplied with this opener in
a prominent place where they are clearly visible.
Choose the side where the opener will be installed,
ensuring there is suffi cient sideroom.
Step 2 - Fit the Weight Bar
The weight bar must be fi tted to the bottom-centre for
proper operation of the opener.
If the door has a handle:
Remove the door handle
Fit the weight bar and refi t the handle using the
new fasteners provided
(Fig.04)
.
If the door does not have a handle:
Locate the centre of the door at the bottom rail
(Fig.05)
.
Place the weight bar at this point (there is a
centreline marked on the weight bar) and mark the
two positions where the fasteners will go.
Drill the two 4.5mm holes in the door and fi t the
weight bar using the new fasteners provided.
(Fig.06)
.
Check that the door is still balanced and smooth to
operate. If it is not, then the door may require servicing
(refer to door manufacturer’s instructions).
WARNING!
The door and its springs are under
signifi
cant tension. Adjustments should only
be carried out by experienced persons, as this
function can be dangerous if not performed under
strict safety procedures.
a.
i.
ii.
iii.
iv.
b.
c.
d.
a.
b.
a.
b.
c.
03
fi g
06
fi g
05
fi g
04
fi g
