Automatic Technology GDO-6v4 EasyRoller, Руководство по установке

Страница: 16 / 36

16 GDO-6v4 EasyRoller ® Owner Installation Instructions
Programming the Opener
13
fi g
Setting Limits: via Transmitter
The GDO-6v4 has the alternate ability to set travel limits
using the transmitter, allowing free movement around the
garage to better assess the desired limit positions.
Step 7.1 - Code a Transmitter for Limit Setting
Ensure the opener is powered up.
Press and hold the DOOR CODE button
(Fig. 13).
Press Button 1 on the transmitter for two seconds
(Fig. 14) . Release and pause for two seconds.
Press the Button 1 again for two seconds.
Release the DOOR CODE button.
Step 7.2 - Setting Limits via Transmitter
Press and hold Button 4 on the transmitter to close
the door. When the door is approximately 2cm from
the ground, press and hold Button 3 for two seconds
and release
(Fig. 14) .
If the door opens, release the CLOSE button and
press the OPERATE button once to change the
motor’s direction, then repeat Step 7.2(a).
Each press of Button 4 will allow you to “inch” the
door closed. Keep doing this until the door reaches
the desired close limit position.
If the door is closed too far, press Button 1 to “inch”
the door towards open.
When happy with the close limit position, press
Button 2 to store this in memory.
Press Button 1 to open the door. When approximately
2cm from the desired open position, press and hold
Button 3 for two seconds then release.
Each press of Button 1 will allow you to “inch” the
door open. Keep doing this until the door reaches
the desired open limit position.
If the door is opened too far, press Button 4 to “inch”
the door towards closed.
IMPORTANT WARNING: The door will
automatically close, open and close again once
Step 7.2(i) is performed . Ensure that no persons
or objects are in the door’s path.
When happy with the open limit position, press
Button 2 on the transmitter to store into memory.
The door will now automatically close and open to
calculate the safety obstruction settings. After this, the
opener can be operated with the OPERATE button.
Step 7.3 - Resetting the Door Limit Positions
Limit positions can be deleted by the following steps:
Press and hold the CLOSE button for six (6) seconds
until you hear three beeps and the CLOSE LIMIT
LED starts to fl ash.
Release the CLOSE button.
Repeat Steps 7.2 to set new travel limit positions.
NOTE:
There is no need to re-code the transmitter (Step
7.1) upon resetting travel limits. The transmitter will still
be stored in memory.
a.
b.
c.
d.
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
a.
b.
c.
Button 1
(Inch Open)
Button 4
(Inch Close)
Button 2
(Set)
14 fi g