Owner Installation Instructions
GDO-6v4 EasyRoller
®
23
31
fi g
Auto-Close
Step 15 - Setting Up Auto-Close Mode
IMPORTANT NOTICE:
It is compulsory to have
Safety Beams installed when using Auto-Close
mode.
Auto-Close mode is a function that automatically closes
the door a preset time after the Safety Beams recognise
that a vehicle has left the garage.
The Auto-Close timer only starts after the Safety Beam’s
path is broken. If the safety beam path is not broken,
the door will remain open until the path is broken. If the
opener incurs a physical obstruction (i.e. not from the
Safety Beams) while closing the door, it will re-open and
not Auto-Close until the Safety Beam’s path is broken
again.
Step 15.1 - Setting Auto-Close Time
Hold down the AUTO CLOSE TIME button
(Fig. 31).
While holding in the AUTO CLOSE TIME button,
press the OPEN button - each press will add one
second to the Auto-Close delay.
To decrease the delay time follow Step 15.1(a)
and press the CLOSE button - each press will
deduct one second from the Auto-Close delay.
Press the OPERATE button or transmitter to open
the door. When the door is fully opened the
OPEN LIMIT LED will fl ash to indicate that Auto-
Close mode is operational.
Break the Safety Beam’s path momentarily to
initialise Auto-Close. When the door reaches the
fully opened position, the door will pause for the
set Auto-Close time and then close.
a.
b.
c.
d.
e.
Step 19.2 - Safety Beam Failure Emergency Close
When the user fi nds that they are unable to move the door and suspect that it is due to a faulty SAFETY BEAM
they can attempt to enter Safety Beam Failure Emergency Close mode by press and holding a pre-coded
button on the remote control or OSC button on the console for fi ve seconds.
Wired Safety Beams Installation
