AUMA SA3-SA100, Руководство пользователя

Страница: 38 / 48

38
• Do not operate the actuator in manual mode while electrically operating.
• Please check the input voltage rating of the motor before giving supply.
• Do not run the NORM actuator without panel.
• Do not bypass the thermoswitch connection in the loop
All AUMA actuators are 100% tested and factory checked. Actuators are supplied ready
for service. Most of the actuators are supplied to valve manufacturers for mounting to
valves. It is usual for the valve manufacturer to set the switches and test the motorized
valve.
Special care should be taken when commissioning.
Wrong connection or faulty control wiring may result in damage to the motorized valve.
In case the actuators will not be mounted or commissioned for a long period, take care for
adequate (dry) storage, refer to our instruction sheet “Transport, Storage and
Commissioning of AUMA - actuators”
4.3.6 Change torque trip value
Change torque trip value can be changed by using below mentioned flow chart and this
flow chat has been derived from "Actuator control flow chart".
4.3.7 Preset torque
Preset torque can be done by referring "Device calibration" flow chart
Weather proof actuators with 3.XMP-SIL &
Data logging