AUMA SA3-SA100, Руководство пользователя

Страница: 37 / 48

37
If inadvertently you override the tripping point, continue turning the spindle slowly in
the same direction till the switch cam goes back to its original position. Repeat
setting instructions as above described.
− Turn thrust bolt I till it snaps back into its original position by spring action.
15. Immediately after start-up : Ensure sealing faces at cover and housing are clean.
Check whether O-ring is correctly in position and apply a thin film of non-acid
grease. Replace the cover and fasten with 4 screws.
16. Fasten control cover screws and tighten glands at conduit entries.
4.3.4 Setting of Mechanical position indicator
The two dials have a slip clutch for easy adjustment. At valve fully closed, turn dial
(CLOSED) till the arrow is in alignment with the mark on the show glass. Operate
valve into fully OPEN position and adjust dial marked (OPEN) till the arrow mark
is in alignment with the mark on the cover.
Note: The dial (CLOSED) must be held in position while adjusting dial (OPEN) . (fig. 22)
4.3.5 Do's and Don'ts - Troubleshooting tips
Setting of Limit switches: Improper methods of declutch mechanism leading to premature failure of tripping
arm.
Improper tightening of covers or missing of o-rings during fitment.
In the events of interchangeability check for the e-pac wiring diagram number.
Do not press mechanical interlock of reversing contactors manually.
Additional Tips
• Do not operate the actuator with improper wiring.
• Do not interchange the cards without checking the e-pac code.
• Do not interchange the e-pac without checking the TOLR rating.
• Improper sealing of cable glands resulting in water entry at site inadvertently
damaging all the electronic cards.
Weather proof actuators with 3.XMP-SIL &
Data logging