ANT
B
ANT
A
RECEIVER
2
GROUND
LIFT
GROUND
NETWORK
INTERFACE
RECEIVER
1
BALANCED
OUTPUT
BALANCED
OUTPUT
GROUND
LIFT
GROUND
NETWORK
INTERFACE
12V
60mA
12V
60mA
WARNING :
THIS APPARATUS
MUST BE EARTHED .
AC IN
T2 AH 250V
max.
250V~
Receiver 1
Receiver 2
6
Part names and functions <rear panel>
(1) Antenna input jack
Each of the antenna jacks can supply 12 V DC for use
with powered antennas or accessories (sold separately).
(6) AC IN terminal
Use the IEC-type connector for 120 V AC 60 Hz power
input.
*This product is only for use in the USA. It may not be used
abroad.
(7) Main power switch
Press the main power switch to turn the power on.
Turn the main power switch on before turning the front
panel power switch on.
(2) Balanced output jack
(6 .3 mm (1/4") standard stereo jack)
COLD
GND
HOT
(3) Balanced output jack
(XLR 3-pin male)
3. COLD
2. HOT
1. GND
(5) Network interface
Connecting to a PC via Ethernet cable allows you to
monitor and control the system from the PC. For
details, contact your local Audio-Technica dealer.
(4) Ground lift switch
This switch isolates the GND pin of the balanced
output from the ground.
Normally use in the GROUND position, but if a hum
develops due to a ground loop, switch to the "GROUND
LIFT" side.
(7)
(6)
(5)
(5)
(4)
(3)
(4)
(3)
(1)
(1)
(2)
(2)
