18
This function allows you to send the settings configured on the product to the transmitter via IR sync.
*First refer to the section "Setting transmitters via IR sync" (p. 14) and then make the settings.
946
a
b
RF
AF
PEAK
+10
0
–10
–20
–30
–40
System Settings
Audio Settings
TX SYNC
(1) From the main menu, turn the control dial, select
[TX SYNC] and then press the control dial.
Ir bus arbitration..OK
Connect..OK
Send and Wait..
Audio Settings
System Settings
TX SYNC
TX Sync
(2) A standby screen is displayed.
◦
Press the BACK button to return to the main menu.
◦
If 60 seconds pass without a button/dial being used,
the display will return to the main menu.
(3) While in standby mode, position the IR sync windows of
the product and transmitter so they face each other.
(4) Press the SYNC button on the transmitter.
◦
Wait several seconds until communication is
established.
Ir bus arbitration..OK
Connect..OK
Send and Wait..OK
Close and End.
Audio Settings
System Settings
TX SYNC
TX Sync
(5) When the sync is complete, the “completed” screen is
displayed.
◦
The settings made on the product are automatically
sent to the transmitter.
◦
After sync is complete, the display returns
automatically to the main screen.
◦
If an error occurs in the syncing process, an error
screen opens and then the display returns to the main
menu. Check the alignment of the IR sync windows of
the receiver and transmitter and then sync again.
◦
To cancel the syncing process, press the BACK button.
Display returns to the main menu.
Setting up transmitter via IR sync
