Atomic AmpliFire, Руководство пользователя, Страница: 45 / 59

45
PARAMETER SETTINgS
CONTINUED . . .
LoW-cUT: Adjusts the roll off frequency of a special low-cut filter, designed to allow
customizing your tone by feeding less lows into the front end input of the guitar
amp model This parameter can be used to “mod” the amp models for a tighter and
punchier tone .
bUTToN: Assign the PRE EQ ENABLE functionality to the selected footswitch .
Pressing the assigned footswitch will toggle between ACTIVE and BYPASS mode of
the PRE EQ . Please note that the assigned footswitch must be in PRESET ASSIGN
mode .
PARAMETRIc 1, 2, and 3
ENAbLE: Turns the effect on or off . Select ACTIVE to turn it on . Select BYPASSED to
turn it off .
TYPE: Selects the type of filter Choose from GAIN ONLY, LOWPASS 1, HIGHPASS 1,
LOW SHELF 1, HIGH SHELF 1, LOWPASS 2, HIGHPASS 2, LOW SHELF 2, HIGH SHELF
2, BANDPASS, NOTCH, or PEAKING (see the PRE EQ section above for a detailed
description of these filter modes)
INSERT: positions the PARAMETRIC (1, 2, or 3) effect Choose PRE to position the
effect in the PRE-EFFECTS section (mono, before the amp model) Choose POST to
position the effect in the POST-EFFECTS section (stereo, after the amp model)
LEVEL: Adjusts the output LEVEL (in dB) of the filter, typically the level of the pass
band of frequencies for the filter (see filter types above for more detail)
fREQUENcY: Adjusts the corner frequency of the filter This can be either the cutoff,
transition, or center frequency depending on the type of filter (see filter types above
for more detail)
Q: Adjusts the Q of the filter which controls the amount of peaking This parameter
has no effect on GAIN ONLY and first order filters (which do not have a Q control)
Increase the Q for sharper peaks / narrower bands Decrease the Q for smoother
transitions / wider bands
bUTToN: Assign the PARAMETRIC EQ ENABLE functionality to the selected
footswitch . Pressing the assigned footswitch will toggle between ACTIVE and
BYPASS mode of the PARAMETRIC EQ . Please note that the assigned footswitch
must be in PRESET ASSIGN mode .