Atomic AmpliFire, Руководство пользователя, Страница: 40 / 59

40
PARAMETER SETTINgS
CONTINUED . . .
T-WAH SENSE (db): Adjusts the sensitivity of the TOUCH WAH. It does so by means
of an input gain control adjustment. Setting this to positive values will make the
TOUCH WAH more sensitive and lower signal amplitudes will more easily move the
WAH to the toe-down position . Can be useful for pickup gain compensation .
T-WAH ATTAcK (milliseconds): Controls how quickly the TOUCH WAH changes from
heel to toe position as input signal amplitude increases . Lower values will cause
the wah to sweep very quickly from heel to toe . Higher values will cause a slower
transition .
T-WAH RELEASE (milliseconds): Controls how quickly the TOUCH WAH change
from toe position to heel position as input signal ampitude decreases . Lower values
will cause the wah to sweep very quickly from toe to heel . Higher values will cause a
slower transition .
WAH Lfo fREQ (Hz): Controls the rate of the Low-Frequency-Oscillator when in
LFO-WAH mode . Determines how quickly the WAH travels from heel position to toe
position and back .
WAH Lfo WAVE (0-100%): Adjusts the geometric shape of the LFO when in LFO-
WAH mode. The LFO shape is adjustable from full triangle wave (0%) to full sine wave
(100%) or anywhere in between.
WAH Lfo dUTY (0-100%): Adjusts the rise and fall time of the LFO whe in LFO-WAH
mode. At 50%, the LFO will rise and fall at the same rate. The percentage indicates
what portion of one LFO period will be spent during the rise. For example, at 25% it
will rise for 1/4 of the total period of one LFO cycle and fall in 3/4 of the period . So it
will rise three times as quickly as it falls .
bUTToN: Assign the WAH ENABLE functionality to the selected footswitch . Pressing
the assigned footswitch will toggle between ACTIVE and BYPASS mode of the WAH .
Please note that the assigned footswitch must be in PRESET ASSIGN mode .
VoLUME
ENAbLE: Turns the VOLUME effect on or off . Select ACTIVE to turn it on . Select
BYPASSED to turn it off .
INSERT: Positions the VOLUME effect into one of three positions, each with a subtly
different control of your sound:
PRE: In the PRE position, the VOLUME effect is placed in the beginning of your
PRE-EFFECTS section (at the input, just after the GATE). This allows you to mimic
the effect of rolling off your guitar volume knob with you foot . It is the same as if
you had a volume pedal as your first pedal in your effects chain .
AMP: In the AMP position, the VOLUME effect is placed right after your AMP
model . This allows you to control the volume of your tone as it is sent to your POST
EFFECTS, allowing tails in your POST EFFECTS to ring out even after turning your
VOLUME effect down .
PoST: In the POST position, the VOLUME effect is placed at the end of your POST-
EFFECTS section . This allows you to control the volume of everything, like a master
volume control similar to the output LEVEL knob .