Atomic AmpliFire, Руководство пользователя, Страница: 22 / 59

22
PARAMETER SETTINgS
CONTINUED . . .
cAbINET
ModEL: Selects the cabinet model and/or cabinet emulation mode . Select NONE
to disable everything: no cabinet model, no ROLLOFF, PEAK Q, BOTTOM, and AIR
adjustment filters (for use with real guitar cabinets). Select FILTER ONLY to disable
the cabinet model only and run the cabinet ROLLOFF, PEAK Q, BOTTOM, and AIR
adjustment filters ONLY. Select MATCHED to automatically select the built-in cabinet
model for each amp model (and filters). Select an amp model name to choose a
specific matched cabinet from the list of available amp models (mix and match cabs
for other amps). Select one of the USER CABS slots to select one of the user custom
impulse response models . Select one of the PRESET cabinet models to copy a cabinet
from one of the other 128 presets. In all modes except NONE, the ROLLOFF, PEAK Q,
BOTTOM, and AIR adjustment filters are active.
ENAbLE: Choose the outputs to have cabinet modeling . This is a GLOBAL parameter .
NoNE: No cabinet modeling (using guitar cabs on either sets of outputs).
MAINS oNLY: Cabinet modeling on the main ¼” outputs only (no cabinet modeling
on the aux XLR outputs)
AUX oNLY: Cabinet modeling on the aux XLR outputs only (no cabinet modeling on
the main ¼” outputs)
boTH oUTPUTS: All outputs have cabinet modeling .
NOTE: Cabinet modeling is ALWAYS on for the HEADPHONE output.
RoLLoff (kHz): Adjusts a high frequency rolloff filter corner frequency to help tame
cabinet impulses that have too much high end. Adjust down to cut off more highs or
adjust up for less rolloff.
PEAK Q: Adjust the peaking of the rolloff filter. The peak is a bump in the frequency
response just before rolloff. A lower value of PEAK Q means less peak. Smooth (no
peak) values are between 0.5 and 1.0. High peaking values are between 1.0 and 5.0.
boTToM (db): Adjust the bottom end shelf of the cabinet model. Use this to reduce
cabinet models with too much low end woof or increase to warm up cabinets that
sound too thin .
AIR (db): Adjust the upper top end frequencies of the cabinet model. Use to add more
sparkle and brilliance to cabinet models that sound too dull or dark .
LEVEL (db): Adjust the output level of the cabinet model. Some impulses have a
different perceived loudness than others . Use this parameter to help balance the level
of a cabinet model with your amp model .