ATN PIAF 10E 2018, Инструкция по безопасности и техническому обслуживанию

Страница: 56 / 81

SAFETY AND MAINTENANCE MANUAL
1NO0055UK-00
PIAF 10 E
56
- Tilt the platform to release it from the platform support to prevent damages with removing it.
(Fig.3 and 4).
PLATFORM INSTALLATION
- Tilt the platform to fit the controls correctly.
- Lower the platform.
- Install the U-clamps on the platform while holding it tight on its support. Tighten the nuts slightly.
- Center the platform on the support and tighten the nuts.
- Reconnect the enable pedal.
- Check the « mechanical » overload detection and adjust it if necessary.
1.4.2 PLATFORM SUPPORT
The platform is held on its support by two U-clamps. The support itself is secured on the jib and
stiffener by 2 pins.
All the electric and hydraulic controls are mounted on the platform support as well as the load
limiter (mechanical overload detection) and its adjustment screw.
Maintenance of the mechanical overload detection is limited to lubrication of the pins. Some
precautions however are to be taken as a simple shock could affect the overload detection setting
and could cause death or serious injuries.
Fig 4
Fig 3