ATN PIAF 10E 2018, Инструкция по безопасности и техническому обслуживанию

Страница: 22 / 81

SAFETY AND MAINTENANCE MANUAL
1NO0055UK-00
PIAF 10 E
22
DANGER
CRUSHING HAZARD
- CONTACT OR CRUSHING THE
PLATFORM ON AN OBSTACLE
MAY
RESULT IN DEATH OR
SERIOUS INJURIES ;
- AVOID CONTACT BETWEEN THE
PLATFORM AND OBSTACLES.
- DO NOT BRING THE PLATFORM
INTO CONTACT WITH OBSTACLES
OVERHEAD.
- DO NOT LOWER THE PLATFORM
ONTO
OBSTACLES OR
PERSONNEL UNDER IT.
- DO NOT SWING THE STRUCTURE
IN
THE PRESENCE OF
OBSTACLES OR PERSONNEL
AROUND THE MACHINE.
- MAKE SURE NOBODY IS IN THE
MACHINE’S EVOLUTION AREA.
- ALWAYS TAKE INTO ACCOUNT
THE MACHINE’S ENVIRONMENT
WHEN DRIVING OR DURING ANY
MOVEMENT.
2.4. FALLING HAZARD
You must take every precaution to avoid falling from the
platform especially if it is raised.
Before entering the platform, ensure the floor and your shoes are clean and exempt from dirt, and
other slippery substances.
In the platform, keep both feet firmly on the floor. Do not climb on the guardrail or on any other
object in the platform.
Never access or exit the platform if it is not fully lowered.
It is recommended to wear a safety harness to prevent any
falling hazard.
2.5. CRUSHING HAZARD
Always be aware of your environment during the
operation of the machine. You must be able to
see what is underneath, above, in front, behind or
next to the platform at all times when moving the
machine. If it is impossible to have a clear view of
the machine’s evolution area, it is necessary to be
guided by another person on the ground.
2.6. ELECTROCUTION HAZARD
Before driving the platform near electric lines,
make sure you have sufficient clearance.
In case of contact with an electric source, the
operator must ask the personnel around the
machine to keep away. Never let anybody use the
emergency control panel without authorization
from the operator. The operator must try and
release the machine using the controls in the
platforms. If it is not possible, the power source
must be
switched off .
In case of contact with a live electric source, the
machine must be checked and repaired by the
manufacture.